At a glance...CML 125/35
spacerSize 127 x 35mm

spacerCover

"Snap-fit" Aluminium
Engages at top.

spacerOutlets

Standard Size
"Centre Mount" Format
spacerStock Colours Grey, Black, White, Stone Beige
spacerSuitable for Category 6 cabling

 

 

  • Based on the "Centre Mount 125" range the "Snap-Fit" system utilises an extruded aluminium cover which "Snap-Fits" into position to provide extra protection and streamline appearance. Ideally suited for use in schools, colleges and universities.
  • Suitable for Category 6 data cabling when used with ECD angled data face plates.
  • The ECD "Snap-Fit" system eliminates the need to screw fix covers and can be mounted horizontally or vertically.
  • The "Snap-Fit" covers engage at the top edge of the duct, avoiding the problem of floor coverings obstructing the fitting or removal of the cover.
  • Duct and covers are powder coat finished. Standard colours are Black, White, APO Grey, Stone Beige. Over 50 non standard colours are available.
  • This product has been examined in accordance with AS 3000 and conforms to A.C.A requirements.

"Easy as ECD"

cml 125/35
Suggested Specification
  • The contractor shall allow to supply and install "Electric Cable Duct Systems P/L CML 125/35 "Centre Mount" skirting duct with "Snap-Fit" extruded aluminium cover (127mm x 35mm) surface mounted or as otherwise nominated and as described below.
  • The system will reflect the integrated voice/data cabling requirements of Category 5 & 6 and have ferrous mounting shrouds for both power and voice /data outlets. Outlets shall be standard size Clipsal, HPM or PDL Type.
  • The body of the duct shall be extruded aluminium pre treated and powder coated to a standard colour (White, APO Grey, Stone Beige, or Black) or as nominated by the architect. The duct cover shall be extruded aluminium pre‑treated, powder coated to match.
  • The system shall be earthed in accordance with AS3000 wiring rules and conform to A.C.A requirements.
  • Bends shall be site mitred to fine tolerances with concealed reinforcing angles riveted in position or alternatively manufactured internal / external bends . Adjacent lengths of duct body shall be splice joined with slide in joiner plates. Slide in stop ends shall be fitted where necessary. The cabling contractor shall retain cables in the duct with custom made cable retainers supplied by the duct manufacturer.
  • Installation shall be performed by experienced duct installers, generally as described on E.C.D "Recommended Installation Procedure" leaflet.

Parts List

Description

Part No

Colour

Duct Body ‑ 3m lengths

CML 125/35

Nominate colour

Duct Cover ‑ 3m lengths

CML 125 C

Nominate colour

GPO Mounting Kit only (no GPO)

CML 125/35 K

Nominate colour

Voice/Data Mounting Kit only (no bakelite supplied)

CML 125/35 VDK

Nominate colour

Internal Bend

CML 125/35 IB

Nominate colour

External Bend

CML 125/35 EB

Nominate colour

Reinforcing Angle (Site mitred bends)

CML 125 RA

n/a

Stop End

CM 125/35 SE

Nominate colour

Flat Bend Plate

CM 125 FB

n/a
 
ecd cable duct - Sydney info@ecdnsw.com.au Phone: 02 9531 0468
Free joomla templates created by Lonex.